Watercolor Flowers Made Easy: Painting with Ink Pads


I love working color onto surfaces in interesting ways.
So playing with water color in unconventional ways was fun. I made a couple cards using watercolors in loose and surprising ways. These techniques require you leave your perfectionism at the door. I will go over one of those methods here.

Supplies

  • Embossing ink and powder
  • Cornstarch 
  • Heat tool
  • Water spritzer
  • Sequins
  • Optional: Stampwheel 2.0

  1. Cut and score an A2 card out of your white card stock and set aside.
  2. Brush a fine layer of cornstarch over a piece of watercolor paper. This will help your embossing powder stick to only the inked image.
  3. Apply your stamp onto this prepared watercolor paper, using permanent black pigment ink.  Then stamp over the same image with embossing ink. I like to use a base coat of black ink to create a crisp outline in case my black embossing powder does not adhere perfectly. 
  4. Sprinkle your embossing powder over your inked image and tap off excess. If you have stray embossing powder, use a clean, dry paintbrush to brush the powder away. 
  5. Use your heat tool to emboss the image.
  6. The embossed lines serve as a waterproof ridge that keeps the water inside the enclosed area. Use your brush to lay a film of clean water over the image you are going to paint. Change your water often so as not to contaminate your color.
  7. Select the colors you want to use from your available water-based ink pads. Uncap your ink pads and lay them face down onto a water resistant surface. You can use a craft mat, a palette or a glass mat as shown here. And rub the ink onto the surface. Deposit about three good smooshes of ink. (Smooshes is my very technical art term.)

  8. Spritz the ink with water until it beads up and you have a puddle of color. Be careful to leave the paint highly pigmented. Do not lighten the color with more water until you want a soft glaze of color. 
  9. Moisten the tip of your brush and then use it to pick up color.
  10. Dab color onto the already wet surface in an area you want to see paint flow. (I.E. the inner petals, close to the center.) The paint will flow outward from the initial deposit of color. 
  11. Allow each layer of color to dry before applying more watercolor. You can use your heating tool, but be careful to not burn the paper by holding it too long over one area.
  12. After you are satisfied with the initial painting, use metallic watercolor to accent select areas. It gives a lovely sheen and catches light beautifully.

  13. Once dry, use the coordinating die to cut your flower out. Also, with the colored card stock, cut out the 4"X5.25" piece you will glue to front of the A2 card.   

  14.  Glue the colored card stock onto the surface of your card. Leave a small, uniform white border showing. 
  15. Stamp a piece of white card stock with the sentiment and use the coordinating die to cut it out. 
  16. Assemble the front of your card. Your vibrant blossom is the star, but your sentiment can balance the composition. 
  17. Give your card an extra touch by glueing a few sequins to your 


    Here is another card in which I used same watercolor technique.
    What I love about this type of watercolor painting is that the brush work is loose and surprises are welcome. As card makers, we measure with care, cut exact, imprint precisely... we are meticulous. So these dabs of color that disperse in wonderful patterns are so fun. Happy accidents. 








Comments